Material Safety Data Sheet - Fine Pipe-Seal 
| IDENTITY (as used on label and list) |
|
|
SAF-T-EZE FINE THREAD PIPE SEAL |
| |
| Section I |
Manufacturers name
SAF-T-EZE DIV., STL COMPOUND CORPORATION
300 EISENHOWER LANE NORTH
LOMBARD, ILLINOIS, USA 60148 |
Emergency Telephone Number
Chemtrec 1-800-424-9300 |
Telephone Number for Information
630-495-2001 |
Date Prepared
NOVEMBER 01, 2006 |
| Section IIHazardous Ingredients/Identity Information |
Hazardous Components
(Specific Chemical Identity, Common Name(s)) |
OSHA PEL |
ACGIH TLV |
Other Limits Recommended |
% (optional) |
| Isopropyl alcohol |
400 ppm |
|
|
|
| All components of this product are listed on the Toxic Substance Control Act (TSCA) inventory of chemical substances maintained by the U.S. Environmental Protection Agency. |
| |
|
Section IIIPhysical/Chemical Characteristics |
| Boiling Point |
180?F |
Specific Gravity (H20 = 1) |
0.9 |
| Vapor Pressure (mm Hg) @ 20?C |
33 |
Melting Point |
N/A |
| Vapor Density (AIR = 1) |
2.1 |
Evaporation Rate (Butyl Acetate = 1) |
1.5 | |
| Solubility in Water |
Negligible |
| Appearance and Odor |
White paste, solvent odor |
|
|
|
Section IVFire and Explosion Hazard Data |
| Flash Point (Method Used) |
T.C.C. 55?F | |
|
|
| |
| |
|
Extinguishing Media |
Carbon Dioxide, water spray, dry chemicals |
| Special Fire Fighting Procedures |
None |
| Unusual Fire and Explosion Hazards |
Vapors are heavier than air and may travel along the ground or may be moved by ventilation and ignited by pilot lights or other ignition sources. |
| |
| Section VReactivity Data |
| Stability |
Unstable |
|
Conditions to Avoid |
| Stable |
X | |
| Incompatibility (Materials to Avoid) |
Strong Oxidizers. |
| Hazardous Decomposition or Byproducts |
As with any other organic material combustion will produce CO2 & possibly Carbon Monoxide. |
Hazardous
Polymerization |
May Occur |
|
Conditions to Avoid |
| Will not Occur |
X | |
| |
| Section VIHealth Hazard Data |
| Route(s) of Entry: |
Inhalation?
Yes |
Skin?
Yes |
Ingestion?
Yes |
| Health Hazards (Acute and Chronic) |
INHALATION: Exposure to high vapor concentrations (>400 ppm) may cause eye, nose and throat irritation and exposure to excessively high concentrations may cause drowsiness or sleepiness, etc. |
|
|
NTP?
NO |
IARC Monographs?
NO |
OSHA Regulated
NO |
| Signs and Symptoms of Exposure |
INHALATION: See Above. EYES: Contact may cause irritation. SKIN: Prolonged contact may cause skin irritation and drying, cracking and defatting of skin. |
Medical Conditions Generally aggravated
by Exposure |
Prolonged skin contact may cause dermatitis in sensitive individuals. |
| Emergency and First Aid Procedures |
INHALATION: Remove to fresh air, if breathing has stopped, give artificial resp. & get medical attention. DO NOT give stimulants. EYE CONTACT: Flush with water, see physician. INGESTION: Do not induce vomiting, call physician. SKIN CONTACT: Wash with soap and water. |
| |
| Section VIIPrecautions for Safe Handling and Use |
Steps to be Taken in Case Material is
Released or Spilled |
Remove all sources of ignition. Absorb material in vermiculite or other suitable absorbent, and place in impervious container for disposal. |
| Waste Disposal Method |
Dispose in accordance with Federal, State, or local laws. |
Precautions to be Taken
in Handling and Storing |
Material is classified as flammable. Keep away from heat, sparks and flame. Keep container closed. Use with adequate ventilation. |
| Other Precautions |
Comply with all Federal, State, and local codes pertaining to storage, handling, dispensing and disposal of flammable substances. |
| |
| Section VIIIControl Measures |
| Respiratory Protection (Specify Type) |
Only required in poorly ventilated areas or in conditions of evaporation from large areas. |
| Ventilation: |
|
|
| Mechanical (General) |
Sufficient | |
|
| Protective Gloves |
Not required unless continued contact | |
| Eye Protection |
Safety glasses recommended | |
| Other Protective Clothing or Equipment |
N/A |
| Work/Hygienic Practices |
Wash hands thoroughly after use. |
The information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions. Any use of the product which is not in conformance with this data sheet or which involves using the product in combination with any other product or any other process is the responsibility of the user.
| |
